2wire third-party wireless Ethernet adapters User Manual

Wireless ClientConfiguration Guidefor third-party wireless Ethernet adapters

6Cisco AironetConsult the documentation provided with your wireless card to install the Cisco Aironet adapter, then follow these steps:1. Double-click

76. Select the System Parameters tab. In the Client Name field, enter a client name. The client name identifies your PC.7. In the SSID1 field, enter t

813. Click OK. The Profile Manager screen appears. Your profile name should now appear in the second line of the Profile Management field, indicating

9D-Link Air DWL-650Consult the documentation provided with your wireless adapter to install the D-Link Air DWL-650, then follow these steps:1. From th

103. Select the Configuration tab.4. In the Mode field, enter Infrastructure.5. In the SSID field, enter the word “2WIRE” followed by the last three d

1113. From the Default Tx Key pulldown, select 1.14. Click Apply.15. Click OK.Apple AirPort cardNote: Requires AirPort client software revision 2.0 or

123. Select your wireless network name. Your wireless network name is “2WIRE” followed by the last three digits of your HomePortal serial number, loca

133. Enable wireless security. Your HomePortal is pre-configured to take advantage of wireless security. Referring to the instructions provided with y

143. The Connect to Wireless Network screen appears. In the Available networks field, select your wireless access point. The wireless access point dis

5100-000059-000 Rev B

Notice to Users©2002 2Wire, Inc. All rights reserved. This manual in whole or in part, may not be reproduced, translated, or reduced to any machine-re

ContentsWireless Client Configuration GuideIntroduction ...

Contents

1Wireless adapter configurationIntroductionAfter your 802.11b wireless adapter is installed in your computer, you must configure it to communicate wit

2Agere ORiNOCO PC Card - Silver or GoldConsult the documentation provided with your wireless adapter to install the Agere ORiNOCO PC Card - Silver or

34. To create your profile, click Add. The Edit Configuration screen appears. Enter a profile name in the Profile Name field. The profile name identif

48. Click Next. In the Set Security field, check the Enable Data Security checkbox. Verify that the Use Hexadecimal (0-9, a-f, A-F) radio button is se

513. In the TCP/IP Behavior field, check the Renew IP Address when selecting this profile checkbox.14. Click Finish. The following screen appears.15.